Case 570 L XT for sale for sale in Claremont, CA
Condition level grade (1-5): 1 2 3 4 5
Condition: Operates As Intended
Engine manufacturer: Case
Serial number: IJG0227279
Additional information: 2000 Case 570 LXT Skip Loader, Case 4-390 Engine, Naturally Aspirated, 4-Cylinders, 2WD - 4WD, 4-1 Bucket included, All Maintenance points serviced, ready to work!
Engine
-Make: Case
-Model: 4-390
-Type: 4-Stroke, Naturally Aspirated
-Cylinders: 4
-Fuel Injections: Direct
Bore Stroke: 4.02\ x 4.72\: 4.02\ x 4.72\
-Displacement: 239 in3
-Horsepower: Gross - 75 at 2200 rpm Net - 71 at 2200 rpm
-Maximum Torque: Gross - 197 lb·ft at 1400 rpm Net - 193 lb·ft at 1400 rpm
Driveline
Fully synchronized 4-speed forward reverse shuttle transmission with hydraulically actuated clutches and clutch disconnect buttons on the transmission shifter and loader control lever. Electronically activated forward and reverse shuttle shift and 4WD engagement with optional mechanical front wheel drive. 4WD activation on-the-go. Maintenance-free, self-adjusting, inboard mounted, wet disc brakes are hydraulically actuated.
Travel Speeds
-Forward: 1st - 3.7 2nd - 6.6 3rd - 12.8 4th - 25.5
-Reverse: 1st - 3.7 2nd - 6.6 3rd - 12.8 4th - 25.5
Service Capacities
-Fuel tank: 31.4 gal
-Hydraulic reservoir: 13.9 gal
-Total hydraulic system: 33.0 gal
Transmission
-2WD Total system: 19.5 qt
-4WD Total system: 22.0 qt
4WD Front axle
-Differential: 5.8 qt
-Planetaries (each): 0.74 qt
Rear axle
-Differential: 15.0 qt
-Planetaries (each): 1.6 qt
-Engine oil with filter: 11.6 qt
Cooling system
-with heater: 17.4 qt
-without heater: 16.7 qt
Electrical System
-Voltage: 12 Volts, negative ground
-Alternator: 12 Volts, 65 amp
-Battery: Maintenance-free 685 cold-cranking amps at 0°F
Loader Dimensions
-Overall operating height: 13'8\ (General Purpose) 14'3\ (4-In-1)
-Bucket rollback at groundline: 40° (General Purpose) 40° (4-In-1)
-Dump angle at full height: 46° (General Purpose) 45° (4-In-1)
Digging depth below grade
-Bucket flat: 7.8\ (General Purpose) 7.1\ (4-In-1)
-Clam open (dozing): NA (General Purpose) 4.4\ (4-In-1)
Dump clearance at full height, 45° dump
-Bucket: 8'8\ (General Purpose) 8'11\ (4-In-1)
-Clam open: NA (General Purpose) 9'8\ (4-In-1)
Dump reach at full height, 45° dump
-Bucket: 25.9\ (General Purpose) 25.3\ (4-In-1)
-Clam open: NA (General Purpose) 11.8\ (4-In-1)
Reach from front axle centerline
-Bucket on ground: 75.3\ (General Purpose) 72.7\ (4-In-1)
-Lift capacity to full height: 5,293 lb (General Purpose) 5,197 (4-In-1)
-Height to bucket hinge pin raised: 11'2\ (General Purpose) 11'2\ (4-In-1)
-Breakout force (dump cylinders): 7,956 lbf (General Purpose) 7,879 lbf (4-In-1)
-Breakout force (lift cylinders) with box scraper: 7,811 lbf (General Purpose) 7,116 lbf (4-In-1)
-Breakout force (lift cylinders) without out box scraper: 6,375 lbf . (General Purpose) 6,175 lbf (4-In-1)
-Bucket cutting edge width: 82\ (General Purpose) 82\ (4-In-1)
-Maximum grading angle: 116° (General Purpose) 116° (4-In-1)
-Maximum clam opening: NA (General Purpose) 38.3\ (4-In-1)
-Moldboard height: NA (General Purpose) 36.8\ (4-In-1)
-Raising time to full height: 4.5 sec (General Purpose) 4.4 sec (4-In-1)
-Bucket dumping time: 0.8 sec (General Purpose) 0.8 sec (4-In-1)
-Lowering time, return-to-dig: 3.1 sec. (General Purpose) 2.4 sec (4-In-1)
Brand: CASE
Model: Case 570 L XT
Year : 2000
|
|